Multi-channel Wide Band Level Detector

Multi-channel Wide Band Level Detector


    

    


		
            


                

					

 

  

   

    


500MHz to 43.5 GHz band level detector（FPC-3000）

    

   

  

 

 

  

   

    


This RF detection unit detects 500MHz to 43.5GHz radio waves and converts them to DC voltage for simple inspection of 5G equipment development and manufacturing (mass production) lines. Up to 9 power detection units can be installed (expanded) and configured with the required number of units.

In the 5G equipment development and manufacturing stage, it is only necessary to measure that “radio waves are emitted” or “radio wave beams are being directed” from the equipment, and pass / fail without the need for expensive measuring instruments such as a spectrum analyzer or tester. Judgment (see next section) is possible. The converted voltage can be output simultaneously with a linearly changing analog output and a digital output that can be imported to a personal computer via USB.

    

   

   

    

    

   

  

 

 

  

   

    


Specifications

    

   

  

 

 

  

   

    


Chassis part






Maximum number of installed units
9 units




Minimum number of installed units
1 units




Applicable unit
FPC-30643 (500MHz – 43.5GHz)




OUTPUT Connector
USB(USB2.0)




Power-supply voltage
AC100V – AC240V 50/60Hz




Size
132.5(H) x 427.2(W) x 370.4(D) mm

Does not include rack mount bracket		





    

   

   

    


Unit section






Frequency
FPC-30643




Dynamic range
500MHz – 43.5GHz




Conversion characteristics
30 dB or more




Conversion voltage characteristic
RMS power measurement




RF input maximum level
30mV/dB




INPUT Connector
2.92mm




OUTPUT Connector
BNC

Multi Connector for FPC-3000		




Conversion output DC voltage
Max 1.5V





    

   

  

 

 

  

   

    


FPC-3000 utilization flow


Reference examples of how to use FPC-3000 are shown in the power test and beam forming test. 


Relative value evaluation method using FPC-3000 is dedicated to prototype model and mass production sample Dell. Use the terminal measured strictly by the measuring instrument as the reference terminal. Mass production started Before starting, each antenna coupler receives the radio waves transmitted from this reference terminal. The FPC-3000 controller uses software to convert the received power into voltage. Stored in master software and saved as master data to complete production preparations and mass production start. 


Place the manufactured terminal in the measurement shield box (our FS-1905). 


In power tests, radio waves are emitted from manufactured terminals and received by antenna couplers. The radio wave is converted to voltage by FPC-3000. FPC-3000 control during production preparation Compared with the master data voltage stored in the software, the preset voltage If it is within the range, it will be judged as “pass”, and if it is outside the range, it will be judged as “fail”. Simple measurement flow suitable for mass production. 


In the beamforming test, the beam is controlled from a manufactured terminal in a specific direction. It emits radio waves. Received by all 9 antenna couplers of FPC-3000 Convert radio waves to voltage, and then come out of the antenna coupler in the intended direction If the received voltage is higher than the voltage from other antenna couplers, it is judged as “Pass” To do. FPC-3000 can realize a simple measurement flow suitable for mass production.